Power Access is a Connecticut manufacturer of an automatic door opener that was designed to assist the handicapped through side hinged doors.

Since 1978, Power Access has concentrated on building openers and related controls to help those that need assistance through side hinged doors. To date many thousands of Power Access openers have been built and installed throughout the USA and Canada.

The principle of operation is simple. We push the door open with a wheeled arm on the operator and close the door by means of a conventional door closer. This means that the door can be used in a fully manual mode as it was before or can be used automatically.

While the unit installation is usually quite simple, we do have a network of dealers who are familiar with the Power Access door opener. They can select the proper unit for the application, install it and back it up with service if service is needed.

Installation Ease

• No modification of the door or jambs
• Plugs right into a regular 115vac wall outlet
• Complete instructions are packed with every unit
• Virtually maintenance free (a couple of drops of oil and a bit of grease every year is all it takes)

Versatile Applications

• Fits in most interior and some exterior door applications
• Left and right hand units are available
• Jamb mount: to push door open or door mount: to pull door open
• Inverted model, for limited room above the door
• Deep reveal and door mounted units for special applications

An Array of Companion Controls

• Push Plate Wall Switches
• Push Button Wall Switches
• Touch Plate Wall Switch
• Coded Radio Transmitter/Receiver
• Keyless Entry Systems
• Electric Door Lock (Strike)

Built in Safety Features

• The operator arm is not attached to the door. Instead, a wheel at the end of the operator arm rolls against the face of the door, pushing the door open.
  • The door can always be opened manually from either side without involving the operator.
  • Traffic flow is not hindered by the operator.
• The Power Access opener is always used in conjunction with a conventional manual door closer, either surface-mounted or concealed.
• Built-in load sensing circuit automatically stops the operator arm and returns to the at-rest (closed) position, if the door meets an obstruction during the opening cycle.
• Thermally protected drive motor
• Adjustable door hold-open time.

The Power Access Operator and controls are covered by a one year limited warranty on materials and workmanship.

For more information on automatic door openers, contact:
Power Access Corporation
106 Powder Mill Road
P.O. Box 235
Collinsville, Connecticut 06022-0235
Phone: 800-344-0088 • Fax: 860-693-0641 • E-mail: slsashm@power-access.com

www.power-access.com

Back to top ▲